Model Prima

evo trenutno pravimo prvi model tocnije dovrsavamo ga


sorry na slici stavim vecu slikano mob. za MMS

zao mi je sto nisam sliko kako sam sta radio ali postavit cu uskoro vise slika s vise detalja

E sad predvidjen je za benzinca ali sam stavio ovaj motor


i regler


* Rotational Speed :790 (kv) RPM/V
* Continuous Current :40A
* Max. Current :50A
* Input Voltage :6 - 14.8V
* Max. Efficiency :98%
* No Load Current :0.6A
* Internal Resistance : 30m(Omega)
* Power : 920W
* Motor Weight (Motor only) : 174g
* Motor Dimensions (Diameter x Length) : 35* 48mm
* Propeller Dimensions : 12" x 7"/ 13" x 7"/ 14" x 7"
* Input Battery Types : NiCd/ Nimh/ Li-po Battery
* Recommend Model : Airplane

ESC Specifications
* Size: 86* 47* 20 mm
* Constant Current: 80A
* Max Current: 90A
* BEC output: 3A
* Input Volt: 6V - 20V
* Low-Voltage Cutoff: Auto detect and set

Advantage of the Speed Controller
-Low resistence
-High rate PWM
-Sixteen cells Max
-Low torque start
-Soft start ramp up
-User programmable brake
-Auto motor cutoff with reset
-Throttle range self-adjusting
-Auto shut down when signal is lost
-Low voltage auto setting based on battery
-Safe power arming program ensures motor will not run accidentally after turn on

* 1 x 80A Speed Controller ESC
* 1 x aeolian 790kv 3548 Outrunner Brushless Motor
* 3 pair x Golden Connector
* Prop Holder & Saver Set

cini mi se da je slican ovome motoru
AXI 2826/12 GOLD LINE

nadam se da ce biti dovoljan za to
model je skoro gotov spojeni su servoi uz pomoc gosp. Lea kojim se ovim putem zahvaljujem
samo jos da poleti iako mi nesta to izgleda sporo okretanje motra mozda ipak 4 celije, sta vi mislite?
uglavnom javim rezultate


Slika modela Prime s neta
tnx Nenadu na pronalazku detalja o modelu

The PRIMA is the ideal aileron-trainer, thanks to its simple and sturdy structure it can be built by modelers with very limited experience. When it comes to flying the PRIMA, we recommend an engine from .15 to .19 (2,5 to 3,5 cc) for basic training.
Switching from a .19 to a .23 (or even a .29) will then make the PRIMA fully acrobatic. This kit contains all the die-cut balsa and plywood parts, a full-size drawing showing both wing-halves, nose- and main landing-gears, all necessary control- horns, nylon hinges and nylon wing mounting screws, assembly instructions, etc

i dimenzije, na francuskom, za motor 2,5-3,5ccm(i do 5ccm)
* Envergure: 1390mm
* Longueur: 97 mm
* Surface: 31 dm²
* Poids: 1800 g
* Motorisation: de 2.5 Ã 5cc 2T
* Fonctions: Profondeur, ailerons, dÃrive, moteur

ipak leo i ja odlucilo smo preraditi i napraviti krilo tj dvomotorac te napraviti avion za fpv